The material and overall structure of the hydraulic system components: the selection of the hydraulic shaft will directly affect the operation of the entire machine and the mechanical properties of the roller after heat treatment. It is necessary to consider the forming process and heat treatment process of the Tile Roll Forming Machine as an effective method to solve the problem of easy fracture of the hydraulic shaft during use. After the heat treatment, the raw materials manufactured will increase, and the density and pressure resistance of the raw materials will be improved as a whole. It can be used for a long time without deformation or breakage.
Material block reading and hardness: The block size and hardness of the material are directly proportional to the requirements of the brick machine material. Use suitable hydraulic rods for materials with different physical characteristics. This helps to extend its service life. Don't panic when you encounter a problem, but make a calm judgment. In the early stages of manufacturing, it is necessary to work hard to reduce possible unfavorable factors to a lower level in order to bring good results in future use.
The gap size of the roller assembly of the tile roll forming machine: the gap between each group of rollers and the rollers should be uniformly stacked, and should not be too close or too far. One pressure is high and the other pressure is low, leading to unbalanced product quality, which is something we need to pay attention to. The above situation often occurs in the production of machinery such as tile roll forming machine, glazed tile roll forming machine, wave plate machine and so on.
Operating power and mass production speed of the tile roll forming machine: In the adjustment of the operation and control parameters of the tile roll forming machine, the power and speed of the rotor are related to the impact hardening degree of the hydraulic rod. Therefore, the service life of the hydraulic system of the tile press will be impaired, and the highest value of the parameter is usually set within this range. It should not be too large or too small to better avoid affecting the service life of the tile roll forming machine.
The tile roll forming machine is a kind of color steel machine, and it is a commonly used color steel sheet forming machine in various construction sites, factories, theaters and other places. The user can customize according to the pattern and size of the color steel plate that needs to be pressed, and the debugging of the tile roll forming machine is also a very important work. It is necessary for professional and technical personnel to guide the operation on site. BMS Cold Bending Machinery puts forward three suggestions on the commissioning of the tile roll forming machine:
1. If the tile roll forming machine shifts to the right when pressing the steel plate, it is necessary to find a hard mat in the lower left corner. If you run to the left, it is the opposite, you need to pad in the lower right corner.
2. The four corners of the front and rear tile machine have the same height from the upper end of the large frame to the bottom shaft. Then find a line by line to straighten it, check whether it is in a straight line, and adjust the left and right sides of the lower shaft to level.
3. Find the center of the front row and the back row of the tile roll forming machine, then firmly lock the mother wheels on both sides, and draw a straight line back and forth in the center of the middle wheel.
BMS Machinery was initially established in 1992. In 2017, we became a member of XIAMEN BMS GROUP and invested 8 factories, 6 machining centers and 1 steel structure company in China, which totally covers an area of more than 30000 square meters.
