Publish Time: 2022-12-06 Origin: Site
Cold forming machine has great influence on the production efficiency of enterprises. What should we do to extend the service life of the cold forming machine? How to maintain the cold forming mill?
l Why do you need to maintain the cold forming machine?
l How to maintain the cold forming machine?
l Conclusion
Special attention should be paid to maintenance during the operation of cold forming machine. Only in this way can we ensure the stable operation of the machine, so as not to affect the normal production, but also to better ensure the service life of the equipment. Some common machine problems are caused by lack of attention to maintenance.
1. Roller: Anti rust oil shall be added to the roll every ten days or so When the equipment is not used for a long time, the roller should also be brushed with anti-rust oil.
2. Cutter die: Cutter die, where friction occurs, in the production process, lubricating oil is added every half a minute to avoid the accelerated wear of the cutter. In addition, when viewing the incision burr is too large to meet the requirements, because the knife edge is not sharp enough, should be dealt with in time, otherwise too serious, the blade or die may be damaged.
3. Punching die: The maintenance of punching die is the same as that of cutting tool die. When the die is not sharp enough, it needs to be smoothed to make it sharper.
4. Transmission mechanism: for cold bending machine, the friction of transmission mechanism is very serious. Here, the transmission mechanism we say refers to: chain, gear, reducer and so on. When these parts work for a long time with high strength, the wear rate is accelerated, so we should pay special attention to the lubrication treatment of these parts. In the tool, chain, gear every half a minute or so to a lubricating oil, reducer should be about ten days to check the amount of oil, each time to add the amount should be based on the actual situation, should keep the oil level to two-thirds of the position.
5. For some unprofessional users, circuit problems are more troublesome, so usually we should pay more attention to protect the circuit, do a good job of dustproof, moisture-proof, oil-proof protection. The wire should be protected from damage.
The above mentioned maintenance methods are strictly implemented by the start-up personnel of the cold forming machine. Only by doing well the above mentioned measures can we prevent problems from happening in the future, so that we will not rush to deal with serious problems when they occur. If you are looking for a good quality and reasonable price of cold forming mill,the BMS company can provide you with the best.